![]() ![]() Turn Off Keypad/Indicator Sound on Brinks Digital Deadbolt So you can also use the mechanical key to lock and unlock. It should be noted that the lock comes with a keyhole and a physical key. To Unlock: Enter a valid User Code and then press the brinks button.To Lock: Press the BRINKS button on the keypad.Enter your favored time value (10 to 99) and then press the brinks button to complete the instruction.Press number 6 on keypad and then again the BRINKS button.Enter your present Programming Code and then the brink s button.You can always set your preferred time delay according to your preference. Keep in Mind that the default time delay before the lock automatically locks is 30 seconds. If you want to disable the auto-lock function, simply repeat the same steps stated above. Now that the auto-lock feature is enabled and it should lock the deadbolt whenever it’s left unattended for 30 seconds. Press the number 5 on keypad and then the BRINKS button.Enter your in use Programming Code and then press the BRINKS button.You can enable the auto-lock function through the following instructions: When the auto-lock function is enabled it will automatically lock the deadbolt after a specific time. Turn the thumb wheel to lock or unlock as normal.Įnable/Disable Auto-Lock on a Brinks Digital Deadbolt.The LED light should stop blinking and stay lit, indicating that you have entered your code successfully. Enter the 4-digit code that you want to use and press “Enter” on the touchpad.This will bring up a 4-digit number pad on your touchpad. Press and hold the “Lock” button on the top of your lock until the LED light starts blinking (about 10 seconds).To add a one-time user code, follow these steps: ![]() The lock will store up to 5 fingerprints or a one-time user code. The Brinks electronic deadbolt lets you enter your home with a simple tap of the finger. Press “enter” to delete them all at once.Īdd a One Time User Code on Brinks Electronic Deadbolt Press the “del” button until it displays all of the codes in memory (up to eight).Enter the new user code you want to use and press “enter.” The lock will beep once and then enter a mode where you can delete all previous codes at once.Enter your current user code and press the “enter” button.Press and hold the “panic” button on your keypad.You can delete the user code for your Brinks digital deadbolt by following these steps: Enter your new user code (up to 8 digits) followed by # Press and release “Lock” (or “Unlock”) button once to confirm code change, or twice if you want to delete that user code.Press and hold the “Lock/Unlock” button on the side of the keypad, until all numbers appear in red, then release the button.Enter your current user code (which is either 0000 or 1111).Press and hold the “Lock/Unlock” button on the side of the keypad, until “LOCK” appears. ![]() This makes it easy to keep the lock secure without having to worry about losing or forgetting your keys. Instead of using keys, the Brinks digital deadbolt uses a 4-digit code that you can change at any time. The Brinks Digital Deadbolt is a great alternative to a traditional keyed lock. Add/Change/Delete User Codes On Brinks Digital Deadbolt The lock will make a beeping sound and flash a green light once, which indicates that the Programming Code has been successfully replaced to new one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |